Application details

In general, you should take the following factors:

• Repair the surface (fill recesses, remove roughness, remove old waterproofing, etc.)  
• Single point preparation (perimeter, pools / drains, expansion joints or structural)  
• Clean the surface or substrate, removing any dust, dirt, oil or bloom.  
• Remove silicone-based products  
• The surface must have sufficient compressive strength of the membrane. If it were not so, this goal  
We will continue to apply our primer resins to achieve adhesion for some substrates  
tests may be required.  
• In general, all surface preparation should be done before application to remove all grease, dirt loose and spilled.  
Requires cleaning of materials.  
The pure polyurea system can be applied to many different surfaces and can be used depending on the nature or situation of the process.  
It will vary. Below are for the most common surfaces  
We have listed some of the applications; Other undisclosed  
For surfaces please contact our technical department.  
Concrete surface: concrete must be fully cured (concrete curing takes 28 days) or every  
In any case, depending on the primer used, the permissible  
The maximum humidity level must be verified. any concrete  
lagging or separating agent must be eliminated and the sand  
An open-pore surface is obtained by spraying, milling or sandblasting.  
should be done. Any cracks and damaged areas can be removed using our epoxy resin.  
It should be repaired using an epoxy grout mixed with silica.

Technical Documents