Before starting the mixing process, make sure that the product temperatures are between + 15⁰C and + 25⁰C. Before mixing, mix components A and B separately with a mechanical drill and paddle at very low speed. Slowly add component B to component A and mix until a homogeneous consistency (About 3 minutes). Pour the contents into a clean container and stir for a few more minutes. Please avoid mixing at high speed and do not add solvents etc. to the mixture during the application process. Do not add.
Application should be avoided in extreme heat or wind, rain and/or when the ambient and/or surface temperature is below + 10⁰C or above + 30⁰C. In extremely cold conditions, heaters should be used to increase the workability of the environment and the product.
After mixing, it can be applied to the surface with a brush, roller, trowel or squeegee. Combination max. 20 minutes at approximately + 20⁰C. To reach its maximum mechanical and chemical resistance, the product will be fully cured in a minimum of 7 days. Reaction times are longer at lower temperatures, which increases pot life, coating interval and working time. High temperatures increase chemical reactions and the above-mentioned time is accordingly shortened. After application, the material should be protected from direct contact with water for at least 24 hours. During this time, contact with water may cause surface bubble formation, carbonation and/or surface stickiness, both of which need to be removed. In such cases, the entire coating must be removed from the ground and renewed.

Technical Documents